KLUBER ISOFLEX TOPAS NCA 52 400g 

 Siemens X4i Mounter maintenance of lubricants 
 Maintenance at: 
 A double paste the titles --- lubrication X and Y axis of the cantilever; 
 Lubrication X and Y axis linear guide - according to a specified amount of grease, too much or too little can damage the bearings; extrusion coated with grease (each about 0.13 cm3) 
 KLUBER UNISILKON L250L 
 ---- Siemens SMT machine lubricants 
 The lubrication skip pulling the plunger pin of the device; 
 The lubrication skip traction ODU connector plunger pin on the device; 
 Vacuum distributor (the back of the Post titles) --- Clean O-ring and a small amount of Unisilkon L250L lubrication; 
 KLUBER NCA52 lubricants: 
 - Maintenance of Siemens placement machines X4I machine 
 The main fuel of the: 
 Lubrication of toothed belt; 
 Coated with a thin layer of grease lubrication Z-axis guide - the rotating surface of the star-axis brake 
 Star-axis brake - grease filled hole in the star-axis brake surface coated with a thin layer of grease; 
 ISOFLEX TOPAS NCA 52 to fill the three holes in the star-axis brake; 
 Valve push rod --- lubrication ring 
 Z-axis (Post titles front) --- a small amount of ISOFLEX TOPAS NCA 52 lubricating gear-belt, and then clear all the excess grease; 
 KLUBER NCA52 lubricants 
 ---- Siemens placement machines for lubricants 

 Lubrication of toothed belt; 
 Coated with a thin layer of grease lubrication Z-axis guide - the rotating surface of the star-axis brake 
 Star-axis brake - grease filled hole in the star-axis brake surface coated with a thin layer of grease; 
 ISOFLEX TOPAS NCA 52 to fill the three holes in the star-axis brake; 
 Valve push rod --- lubrication ring 
 Lubrication of the X-axis and Z axis (Post titles front) --- a small amount of ISOFLEX TOPAS NCA 52 lubricating gear-belt, and then clear all the excess grease; 
 Lubrication of X and Y axis linear guide - according to a specified amount of grease, too much or too little can damage the bearings; extrusion coated with grease.